AlgerRoland
Industry info Wiki Q&A
Q how to use oxy acetylene cutting torch
FrancesNorton
AlgerRoland Release Time: August 7, 2024, 2:20 PM
Using an oxy-acetylene cutting torch involves several steps for safe and effective operation. First, securely attach the oxygen and acetylene tanks to the torch setup. Open the acetylene valve slightly and ignite the gas with a striker, adjusting until you get a stable, soot-free flame. Slowly open the oxygen valve on the cutting torch handle to introduce oxygen into the flame until it becomes a sharp, blue flame known as a preheating flame. Position this flame close to the metal, allowing it to preheat to a bright cherry red. Once heated, press the oxygen lever to blast oxygen through the metal, moving steadily along the line you wish to cut. Safety is paramount: wear appropriate protective gear, work in a well-ventilated area, and ensure there are no flammable materials nearby.
0
Q how to get a neutral flame oxy acetylene
AlgerRoland
RitaBloomfield Release Time: August 6, 2024, 6:59 PM
To achieve a neutral flame in oxy-acetylene welding, begin by turning on the acetylene valve and ignite the torch. Adjust the acetylene until the flame has a clear inner core. Next, slowly open the oxygen valve until the acetylene feather just disappears, leaving a bright, well-defined inner cone. This indicates a neutral flame, characterized by an equal ratio of oxygen to acetylene. It’s ideal for most welding tasks as it provides the right balance of heat without introducing excess oxygen or carbon into the weld area, ensuring a clean, strong joint. Always wear appropriate safety gear and consult the equipment’s manual for specific instructions tailored to your welding setup.
0
Q what psi for oxygen and acetylene
GriffithBush
HardyWheatley Release Time: July 22, 2024, 12:38 PM
When setting up oxygen and acetylene tanks for welding or cutting, the correct pressures are crucial for safe and efficient operation. For oxygen, the typical pressure setting ranges from 20 to 60 PSI (pounds per square inch), depending on the cutting or welding application’s requirements. For acetylene, it is much lower, as acetylene becomes unstable at pressures above 15 PSI. Therefore, the working pressure for acetylene is usually set between 5 and 15 PSI. It’s imperative to consult the equipment’s manual or guidelines for the specific task at hand since the correct pressures can vary based on the torch type, nozzle size, and material being welded or cut. Safety should always be the top priority, so ensuring correct pressure settings will not only provide optimal performance but also prevent accidents.
0
AlgerRoland Release Time: July 22, 2024, 6:46 AM
When setting up oxygen and acetylene tanks for welding or cutting, the correct pressures are crucial for safe and efficient operation. For oxygen, the typical pressure setting ranges from 20 to 60 PSI (pounds per square inch), depending on the cutting or welding application’s requirements. For acetylene, it is much lower, as acetylene becomes unstable at pressures above 15 PSI. Therefore, the working pressure for acetylene is usually set between 5 and 15 PSI. It’s imperative to consult the equipment’s manual or guidelines for the specific task at hand since the correct pressures can vary based on the torch type, nozzle size, and material being welded or cut. Safety should always be the top priority, so ensuring correct pressure settings will not only provide optimal performance but also prevent accidents.
0
You May Like
Q&A
Popular Information
Contacts Us:
Tel：WhatsApp +1 (443) 226-3000
email：service@tdd-global.com
User Agreement Privacy Policy Cookie Policy Intellectual Property Protection Policy About us
Copyright © 2021-2025北京涂多多电子商务股份有限公司All Rights Reserved
About Cookies On This Site
We use cookies to give you the best possible experience on our website. For more details including how to change your cookie settings, please read our Cookies Policy